Help with Precision Port Enclosure for FI Q 10D2 for Center Console

[papa69smurf 0]

Hello, this weekend I hope to construct a center console for my truck.

 

The vehicle is a 99 ram 1500 quad cab

The box will take place of the center bottom seat cushion, allowing the top flip up portion to still be utilized as storage.

The box will house 2 FI Q10 D2 subs with everything but high qts option

The box dimensions are H:10" W:15" L:30"

Box material will be 1/2 birch ply home depot project panels

Box gross volume is 2.11

Port will be precision port dimpled inner + outer flare 4" diameter 24 inches long for a net volume of 1.67 cuft and port tuning frequency of 27.43Hz according to torres.

 

Box will have flame kissed woodgrain with a very dark cherry stain and shalaq for a beautiful finish that matches the dash bezel.

 

Does this seem like a reasonable setup? Any input is welcomed thank you

[smashedz28 110]

Sounds like it could be clean. Take lots of pictures

[papa69smurf 0]

Will do just picked up some 23/32 auraco today, it matched the woodgrain better and had virtually no voids