dynamat

[denalilvr 0]

would 36 sq ft in the sizes of 18''x32'' be enough to do the whole back part including roof and doors of a gmc yukon? im trying to figure out how many kits i will need..so any opinions would be great..

[shizzzon 461]

ur runnin the Saz-3000D?

I was told by SecondSkin that with that much power to use 3 layers of Damp Pro.

So... I would advise goin that route by means of probably just ordering a bulk package.

I own a 2door coupe and i'm installin 260sqft minimal until i get my setup in to see what else i'll need.

[johnecon2001 82]

You could always whip out a handy tape measure and go nuts.

And amplifier doesn't really mean squat as far as deadening goes. Many more factors to consider before telling someone to do 3 layers based off of using one SAZ-3000D.

[denalilvr 0]

i was thinking around 108 sq ft..it gets pretty expensive at $60 for 36 sq ft..lol

Edited March 30, 2008 by denalilvr

[shizzzon 461]

well i know power doesnt reference how much specifically but i assume he told me that in regards to an average daily setup.

You can always go back over specific areas with spectrum or sludge.

[denalilvr 0]

so basically im looking at 27 sheets at the size of 18''x32'' for about $180 i think..

[///M5 2,833]

Don't buy that stuff in sheets, get some Raamat or Secondskin.

[denalilvr 0]

i clicked the banner above to one of these sites that sells this stuff for the same amount it was about $200+ i think...and another site had 5-6 different kinds..lol

Edited March 30, 2008 by denalilvr

[bigjae1976 0]

I think 1 60 sq ft roll of raamat will work.

[mrogowski 6]

B-Quiet is another alternative..

[Aaron Clinton 2,372]

Damplifier pro, just one layer in most parts so far, has made a huge difference in the Honda for me.

[denalilvr 0]

im going to look into all the suggestions..im trying to stay at $200 or under to do the whole truck..

[Aaron Clinton 2,372]

Then my vote is Damplifier.