12" BTL cutout?

[blimblam 0]

so, i got an enclosure built for my 12" BTL (single slug motor) but the magnet refuses to fit into the cutout. i was wondering what the cutout diameter would make it fit.

i can't trim the cutout because its only enough for the cutout itself since the box is 14"H with only .25" clearance on the top and bottom.

[NDMstang65 403]

Hair over 11.25" and the motor will drop in the hole.

[rodneydude23 5]

Haha wowwww that's a beastly magnet

[blimblam 0]

Hair over 11.25" and the motor will drop in the hole.

dammit! the site had it at 11.125 so the guy that made it did it at that. alright thanks.

heads up so you might want to change it on the site.

Edited July 9, 2009 by blimblam

[NDMstang65 403]

Take the magnet boot off and it'l drop right in.

It won't fit with the magnet boot on, there's supposed to be a piece of paper in the box with the 12's but the guys in the shipping department might have forgot to put it in there.

[blimblam 0]

Take the magnet boot off and it'l drop right in.

It won't fit with the magnet boot on, there's supposed to be a piece of paper in the box with the 12's but the guys in the shipping department might have forgot to put it in there.

oh, alright cool. i bought it used off of acex3a. i didnt know i could take that boot off. thanks man. greatly appreciate it. ill try when i get home from work.