XCON 12

[ShaiTan 0]

Does anyone know the exact mounting hole diameter for the XCON 12? Not the individual hole size. But the entire mounting circle.

[cheese20323 13]

If your trying to make it flush mount just take out the rubber thing and trace there you go...

[Sir-Lancelot 216]

Dang bro, it's right on the page where you ordered them,.

•Sub Outside Dia.: 12.500”

•Cut Inside Dia.: 11.150"

[ShaiTan 0]

Dang bro, it's right on the page where you ordered them,.

•Sub Outside Dia.: 12.500”

•Cut Inside Dia.: 11.150"

That is the outer diameter and the cutout diameter. I want the screw hole diameter around the sub.

[Sir-Lancelot 216]

My bad

reading > me.

[Sir-Lancelot 216]

I just set them in there and hit the holes with a Sharpie, then take it out and drill holes.

Helps me make sure i am centered too so I dont drill a hole too close to the edge that wont hold a screw.

[jcarter1885 995]

I just set them in there and hit the holes with a Sharpie, then take it out and drill holes.

Helps me make sure i am centered too so I dont drill a hole too close to the edge that wont hold a screw.

x2, the same method I use as well.