runing rca for 6 amps

[SamuelHermon 0]

so what would be the best way to run rca for 6 amps?

HU has 3 rca outputs front rear sub,

and if i understand corectly i can only do 1 amp in master and 1 in slave, so this would b ring me down to 3 for my sub amps what would be the next route?

[pmureika 31]

so what would be the best way to run rca for 6 amps?

HU has 3 rca outputs front rear sub,

and if i understand corectly i can only do 1 amp in master and 1 in slave, so this would b ring me down to 3 for my sub amps what would be the next route?

Y adapters but not sure.

[ralstonballa2413 20]

Are all 6 for your subs?

[StreetLegal 119]

Usually, you use a combination of the rca pass throught on the amps (if available) and rca Y-adapeters

[S.DeYoung 967]

http://www.hifonics.com/Hifonics_Maxxlink.html

[SamuelHermon 0]

Are all 6 for your subs?

yes

6 15s-6 amps,

also

1 amp off of front for tweets and 1 amp off rear for mids,

total of 8 amps all together

[pmureika 31]

Are all 6 for your subs?

yes

6 15s-6 amps,

also

1 amp off of front for tweets and 1 amp off rear for mids,

total of 8 amps all together

Why a amp for each sub?

[SamuelHermon 0]

Are all 6 for your subs?

yes

6 15s-6 amps,

also

1 amp off of front for tweets and 1 amp off rear for mids,

total of 8 amps all together

Why a amp for each sub?

if i do an amp on each sub i can run at 2ohm load for starters and if i decide to down the road i can add a 2nd woofer on each amp

[pmureika 31]

Are all 6 for your subs?

yes

6 15s-6 amps,

also

1 amp off of front for tweets and 1 amp off rear for mids,

total of 8 amps all together

Why a amp for each sub?

if i do an amp on each sub i can run at 2ohm load for starters and if i decide to down the road i can add a 2nd woofer on each amp

Ok

[Jason Witt 65]

I would also consider a line driver as well for clean signal to so many amps.

[jokers10 19]

What is a 15s-6? If it is a normal amplifier you can just use the RCA outputs. If you are not strapping the amps you are never running into a master/slave situation. You are simply passing the signal from amp to amp. It is only a through however so the signal might be reduced for 6 amps, so I would also recommend a line driver.

[jokers10 19]

lol, I misread that. six 15s, six amps. Yeah what I said above.