3 audioque HDC3 10's

[Julian 641]

I am looking for a box design for 3 audioque HDC3 10's my trunk specs

H 16 in

L 43 in

W 36 in

the mouth of my trunk is 44in

looking for a 4.5 cuft box tuned to 36/37 hertz i don't know how much port area though,

Edited November 30, 2009 by Julian

[shizzzon 461]

I'm interested in designing it for you but i have some trunk measurement questions.

How wide is it from wheel well to wheel well right behind the back seat?

Once past this area moving back, how deep is it from the point the wheel well area starts to widen to the back of the trunk?

What is the width in the back of the trunk ocne the trunk widens as much as possible?

What is the height with the trunk closed if the box was built wide enough to sit under your trunk lid arms? I don't want the box to hit these things.

[Julian 641]

from the wheel well to the seat there is little to no space maybe 3 inches

47 inch after the wheel well

and the box was to be built inbetween the two arms

[shizzzon 461]

so your saying in between the trunk arms is 43" wide?

How deep can 43" wide remain 43" wide from the back of the trunk going forward toward the rear seats?

You say 36" in your first post but it doesnt look like that's possible.

[Julian 641]

oh i didnt understand at first

from bar-bar there is 38in of space between them

and when the trunk lid is closed from the bottom of the bar there is 6 inches from the bottom of the floor

[shizzzon 461]

oh WOW, so the trunk arms lower 10" from the top? that's insane....

Ok, well, lol, can't go no wider than 38" then...

How deep can i go from the back of the trunk to the front of the car maintaining 38" wide?

[Julian 641]

what do you mean by deep?

[shizzzon 461]

that's what i mean.. DEEP....

From the Rear of the trunk to the back seats... the depth..

I need to know how deep i can maintain 38" wide x 16" high.

[Julian 641]

oh 43 inches its slanted like so /

[shizzzon 461]

ok, i got a design for you-

It's around 5 cubes NET tuned to ~36.5hz

[Julian 641]

ooh i like it!

actually love

any measurments and such? more angles. also can you PM me the design i have google sketchup also