setup help

[llplayboypep 0]

ok the box got alot of air flow..an the person im trying to be louder than has 4 cvrs 2 ohms on two lanzar 2000 watt amps. 

my brother has the same subs on two 2200d audioque amps... 

[EPerez 236]

Build a good box with your equipment and you might be able to be louder. 2 totally different systems with you and your friend.

[audio-neon 34]

I'm going to try and make this as simple as possible.

 

If you are trying to compete, you will want a completely different box tuned much higher, closer to 50hz for competitions (assuming you are doing burps). (Which won't give you the loud lows because frankly competitors don't use low frequency burps to compete because they aren't as loud).

 

As far as speaker wire from the amp to the sub, nothing larger than 12 ga. is necessary, and will not yield any discernible improvement.

 

As far as an improvement in the amplifier department, what is your budget?

 

Lastly a properly built box is the single greatest improvement you can make in any system.

[AXEHAMMER 16]

I'm going to try and make this as simple as possible.

 

If you are trying to compete, you will want a completely different box tuned much higher, closer to 50hz for competitions (assuming you are doing burps). (Which won't give you the loud lows because frankly competitors don't use low frequency burps to compete because they aren't as loud).

 

As far as speaker wire from the amp to the sub, nothing larger than 12 ga. is necessary, and will not yield any discernible improvement.

 

As far as an improvement in the amplifier department, what is your budget?

 

Lastly a properly built box is the single greatest improvement you can make in any system.

^^Listen to this OP. As stated before, you need to change your box before blowing money on amps....will make a much bigger difference than just replacing amps.

[llplayboypep 0]

Ok a solid box or seal

[pmureika 31]

Ok a solid box or seal

Use a ported box!

[///M5 2,833]

Ok a solid box or seal

or

More seriously neither. Ported is what you need.

[pmureika 31]

Ok a solid box or seal

or

More seriously neither. Ported is what you need.

That was a good one.

[llplayboypep 0]

Ok thats what im.going to go with mdf board

[pmureika 31]

Ok thats what im.going to go with mdf board

But you need to make sure its the right size and is ported to the proper frequency. The right box is the most important part of the build!

[llplayboypep 0]

Ight thts.what imma do

[llplayboypep 0]

Ok thats what im.going to go with mdf board