Beefing up amps

[Austin863 84]

Does anyone know of where i could send my amp to get fixed and or beefed up a little bit? just curious. i burn a cap in my 3k and i was looking to maybe send it out and get that fixed but also beef it up and have them make it one Ohm stable. Its an Audiopipe Ap 3000.1d.

 

[///M5 2,832]

"Beefing" up an amp isn't trivial. Would be way cheaper to buy a different amp and sell what you have than to pay someone to re-engineer what you bought.

Somewhat shocked that it is a sub amp that isn't 1 ohm stable though.

[ricksi30 923]

"Beefing" up an amp isn't trivial. Would be way cheaper to buy a different amp and sell what you have than to pay someone to re-engineer what you bought.

Somewhat shocked that it is a sub amp that isn't 1 ohm stable though.

It's two strapped 1500's in one case.

[Austin863 84]

"Beefing" up an amp isn't trivial. Would be way cheaper to buy a different amp and sell what you have than to pay someone to re-engineer what you bought.

Somewhat shocked that it is a sub amp that isn't 1 ohm stable though.

Well the amp is 2 ap1500.1d's straped in one casing. but i burnt a cap so i was wondering if anyone knew where i could send that to get it fixed?

[Austin863 84]

if its just a snap in capacitor that is blown. I can just pop that out and put in a new one. Correct? thats all i can see that is messed up i mean i could take it and have it check but if its just the cap ill buy the same one and just pop that one out and put a new one in. another question what kind of glue do they use?

[Austin863 84]

http://www.newark.com/multicomp/mchpr100v188m25x41/capacitor-1800uf-100v/dp/55T0395#accessories

[Austin863 84]

the cap in the amplifier is 1800 uF 100v VENT -40 + 105 degrees C

[djjdnap 78]

Probably more than just a cap.

 

Usually the transistors go out.

Spiking the voltage or current burning up the board.

 

And your supposed to change those in however many are connected together pairs.

 

http://www.bcae1.com/repairbasicsforbcae1/repairbasics.htm

[nem 2,013]

Yes as dj said chances are there is more damage. If you want bring it down and I will troubleshoot it and see what all is bad. The bad thing is that amp has surface mount parts which I can't replace, but hey I can look for you. As Newark is where I get my parts.

[nem 2,013]

Before you order that call them because yours might not be the same physical size as the one shown.