Strongest bonding agent for Steel to wood?

[Tirefryr 1,742]

You can countersink the screws and the volume taken up by the screwheads would be negligible anyways.

[djjdnap 78]

yea i would said a bolt through the wood,

tack weld the bolt the steel.

or bolt and nut.

orrrr

DUCK TAPE!!!! lmao

[Dutchie. 10]

Looking forward to seeing how it holds up. You could also tack weld the top of that steel brace to the car, then just bump the tacks with a grinder when you need to remove them.

[shizzzon 461]

yea, i would have welded steel to steel whenever i have the chance but time is of the essence and i dont have access to a welder 24\7 so when i need to adhere... if the welder isn't here, glue it is...

I am still debating on running a bolt through the steel to steel part and just drilling out a hole for the side walls to go around the bolt head but just havent got to that part yet.

[shizzzon 461]

and the only welder that's been used on this car is a mig welder. it works perfectly fine with the steel i'm using.

The flooring is mig welded and dead level right now.

[shizzzon 461]

http://s303.photobucket.com/albums/nn147/shizzzon/?action=view&current=video-2011-04-19-11-33-37.mp4

[ssh 924]

"Oh yeah, I like this glue"

[shizzzon 461]

i'm bout to glue the shit out of everything in a minute.

[ssh 924]

heh, looks like the stuff work wells. Curious to see once everything is done, if 15xdB+ rips it apart or not.

[shizzzon 461]

well you'll never know at that point because you'll never see it once the wall is built.

[ssh 924]

Then I hope it works

[topgun 262]

Drill a hole and put a bolt through it...

[shizzzon 461]

dont worry, hehe, i have MANY anchor points in this car..

I'll be removing the headliner soon and then the car will be bare.

floor, sides, top and angle iron in the back.. all anchor points.

[shizzzon 461]

Drill a hole and put a bolt through it...

I will sir on each side of the car.

[djjdnap 78]

if that would would have came off while u was pullin on it.

good stuff seems like though

[kryptonitewhite 1]

My PL PRO has never come undone, 2"x6" framing to steel, 2"x4", and 3/4" MDF.